MOTUC Castle Grayskull Q&A With Mattel's Scott Neitlich

by Jay Cochran
February 27, 2013 posted a Q&A with Mattel's Scott Neitlich. Check it out below.

Hey everyone! I know their have been a ton of questions about the Castle and Val and the Mods were nice enough to gather together the most pressing questions. Please keep in mind that everything about the Castle is in flux right now as development continues. No one has really tired anything this ambitious before (selling in a 250.00 playset with a B-sheet!) so we do ask that you bare with us as development continues. There are and will continue to be changes from the original B-sheet as we move into sculpt (as seen at NYTF) and final toy (which we hope to show at SDCC).

If in any way you are unhappy with the product as it develops you may cancel your order through Aug 30th. But keep in mind if you cancel you can’t get back in and it is likely we will not do a day of sale for the Castle (or if we do it will be super limited and maybe only customer service stock sold off if not needed). Hope these answers clarify and feel free to ask more over on the “ask Matty” forums!


1. Will the jawbridge hinge be lowered further and/or the entrance way increased in height to allow for a longer jawbridge and more clearance for figures (or even better, clearance for He-Man on Battle Cat)?

We are actually looking into this. At this point it is too early to confirm anything but Mattel design and the Four Horsemen are exploring ways of getting the Jaw Bridge to lower into the base a bit more to allow for more clearance. We are actively looking into this to see if it is possible.

2. Can the Windraider socket be moved to the top somehow and/or the lower base be removed and something else be done in its place, such as the addition of other highly requested features or items (like the 3D dungeon) not currently offered with Grayskull?

The WR socket was always planned and announced as being inside of the Castle. The idea of "replacing it" does not really work. The socket is a hole in the floor of the castle for the existing stand included with the released WR toy. Replacing this "socket hole" with a newly sculpted item with lots of deco (like the dungeon you suggest) is not a 1:1 cost ratio. A new item with deco is way more expensive vs. including a socket in the floor. But if you don't want to use the Windraider socket or even the entire floor section you do not have to. This optional floor section with the WR socket plug is an accessory for the Castle and not needed to hold the playset together the way the walls do. If you don't care for this feature you do not need to display it. It is optional.

3. Will the inside walls of Grayskull be sculpted to add detail and features rather than being smooth as we saw in the prototype?

The interior walls will be the inverse sculpt of the exterior walls. They were smooth at Toy Fair in the Four Horsemen sculpt. But was noted at the show as being a temp item to hold the prototype together. The final plastic castle will have one sculpted wall for the outside and inside.

4. Will the throne be adjusted to allow for the Sorceress and/or a caped figure to sit in?

Yes, we are exploring adding a slit in the back of the throne for the Sorceress's tail feather to slide into letting her sit properly.

5. Will you adjust the trapdoor so it drops directly onto the dungeon or into the prison?

No, there will not be changes to the trapdoor position.

6. Will you go back and make Grayskull larger like in the foam mockup? And if not, why was it scaled down in size?

No. This is the largest we can make the Castle at the current price point. The foam model and the sell in sheet was noted as a work in progress and all dimensions given were noted as estimates that would likely change. And they did slightly.

7. Can head clearance inside the castle be improved for the figures placed inside on the different floors?

No, we won't be able to adjust the spacing of the floors, but there is more than enough space for MOTUC figures on each section.

8. Will the missing accessories from the original playset and other items like the 3D dungeon and Mark Taylor concept accessories be offered separately in the future if we cannot get the with this Grayskull playset?

We don't have plans for any additional accessories to the actual Castle (in fact there is a good chance some of the items shown at NYTF may need to be cut before the final product is shown at SDCC as costs continue to come in). It is always possible we could look into an add on "furniture" or "accessory" pack for the Castle one day, but nothing is planned right now.

9. Will there be pegs on the ledges to keep the figures from falling, or will you make the ledges wider so pegs aren't needed?

No. We won't be adding pegs to the ledge. There is more than enough space for two MOTUC figures to fit. Eric confirmed this on Roast Gooble dinner last week. (note from JVS3: I hope to have the episode up this coming weekend)

10. Will a cap be provided to cover the Wind Raider stand socket when it's not used, plus can something done with texture and sculpting to help make the floor look better?

No, we won't be adding a cap to the WR socket. It is an option piece and you can choose to not display it with your Castle if you do not care for it.

11. Is Grayskull designed for the potential future additions like Point Dread, castle playset extensions and/or dioramas?

Yes, the Horsemen did sculpt it with this in mind, but no plans right now for any additional items like you describe.

12. Will the spacesuit armor ever be offered as an articulated figure, or a snap-on piece that will cover an existing figure?

It is always possible but we don't have any plans right now for this.

13. Will fans be polled for what features, accessories and items they'd prefer on Grayskull?

No. The only poll we are running is for preorder customers to choose which 10 figures will be on the box art.

14. Can we get more features or additions (like a portal) that are nods to Filmation Grayskull?

No, we won't be adding any additional accessories and there is a very good chance that some of the accessories shown at NYTF may not make it to the final product as costs continue to come in. We'll have the final toy to show at SDCC.

15. Will you change the prison's size and bars so you can fit more inside and so you can see more of the figure through the bars?

No, we won't be able to make this change.

16. Will all the materials used, especially on joints and hinges, be stable and of the highest quality to insure durability, with the possibility of replacement parts and a lengthier warrantee?

We are using the best material we can!

17. Will Scareglow's key work on Grayskull?

Yes, there will be a slot added to the back door that will fit his key.

18. Will the hinge allow for the two halves to be taken apart after the initial assembly?

Assembly is not final at this time so we don't have a final answer to this.

19. Will a book, comic or unannounced accessory come with Grayskull?


20. Will this Grayskull ever be used for another incarnation of MOTU, such as 3 and ¾ figures?

There are no plans to re-release the Castle beyond the current sale.

21. Will the two halves open up completely so they are perfectly side-by-side and will sit flush against a flat surface?

Assembly is not final at this time so we don't have a final answer to this.

22. Will you make the left parapet taller?

No, we won't be able to make this change.

23. Will the walls of the castle remain thick?

No, the sculpt at NYTF had much thicker walls to hold the prototype together. In the final plastic product the walls will be the inverse of the exterior sculpt detail.

24. Will any of the interior show when Grayskull is closed (like the top of the elevator rails) and if so, can it be fixed to conceal anything inside when closed?

It will be very similar to the vintage Castle. You will likely see some section of the elevator but we are not far enough along to make a definitive call.

25. Can the green on the castle be made darker?

Deco is not final but it is pretty close. We'll pass this along but likely we are past the point of making this change.

26. Will extensive testing be done to make sure paint will adhere and not easily scrape off Grayskull?

All of our products have this.

27. Will the sword keyhole be disguised in any way to make it less visible when not used?

It will look like a vertical crack in the front stone by the Jaw Bridge.

28. Are the shields, sword holder and tapestries removable?

The swords and shields can be removed, but the wall mounted holder is one time assembly. You can interchange which swords and shields are on the wall to your heart’s content.

29. Can the flags be made out of a sturdy fabric?

The flags are made of plastic.

30. If any paint aps are cut, will stickers be included to make up for any lost paint?

That would be one option, but we are pretty set on the paint ops at this point!

31. Will there be a lock on the orb chamber that you can open with the Sword of Power or Sword of Protection?


32. Will the laser canon swivel left to right as well as up and down?

It moves up and down on the stand, but it is also not in a fixed spot so you can move it wherever you want.

33. Will you add a plug-in to attach Castle Grayskullman in some way?

You can put him anywhere you want, but there is no attachment for him.

34. Will the elevator have more paint aps?

No, we are not adding additional paint aps. But it has a lot.

35. Will you make a set of thrones to sell separately to use with the King and Queen?

It is always possible but we don't have any plans right now for this.

36. Do Castle Grayskullman's swords fit into the sword wall mount?

The wall mounted sword holder will fit most MOTUC swords/weapons.

37. Will the flags turn on the poll, or will the poll be able to rotate to show different sides of the flag?

The flag is fixed and made of plastic. The poll is a self standing element that can be moved or positioned anyway you want on the top, inside, next to the ground or even in your refrigerator if that if your thing.

38. Will it come with an Orb for the Orb Room?

No. The orb came with King Grayskull in late 2011.

39. Will we get He-Ro's grave?

No, we won't be including a grave stone accessory. Only what was shown at NYTF and possibly not even all of those items as costs continue to come in. A final toy will be shown at SDCC.
Image 1 of 76
1 of 76
Image 2 of 76
2 of 76
Image 3 of 76
3 of 76
Image 4 of 76
4 of 76
Image 5 of 76
5 of 76
Image 6 of 76
6 of 76
Image 7 of 76
7 of 76
Image 8 of 76
8 of 76
Image 9 of 76
9 of 76
Image 10 of 76
10 of 76
Image 11 of 76
11 of 76
Image 12 of 76
12 of 76
Image 13 of 76
13 of 76
Image 14 of 76
14 of 76
Image 15 of 76
15 of 76
Image 16 of 76
16 of 76
Image 17 of 76
17 of 76
Image 18 of 76
18 of 76
Image 19 of 76
19 of 76
Image 20 of 76
20 of 76
Image 21 of 76
21 of 76
Image 22 of 76
22 of 76
Image 23 of 76
23 of 76
Image 24 of 76
24 of 76
Image 25 of 76
25 of 76
Image 26 of 76
26 of 76
Image 27 of 76
27 of 76
Image 28 of 76
28 of 76
Image 29 of 76
29 of 76
Image 30 of 76
30 of 76
Image 31 of 76
31 of 76
Image 32 of 76
32 of 76
Image 33 of 76
33 of 76
Image 34 of 76
34 of 76
Image 35 of 76
35 of 76
Image 36 of 76
36 of 76
Image 37 of 76
37 of 76
Image 38 of 76
38 of 76
Image 39 of 76
39 of 76
Image 40 of 76
40 of 76
Image 41 of 76
41 of 76
Image 42 of 76
42 of 76
Image 43 of 76
43 of 76
Image 44 of 76
44 of 76
Image 45 of 76
45 of 76
Image 46 of 76
46 of 76
Image 47 of 76
47 of 76
Image 48 of 76
48 of 76
Image 49 of 76
49 of 76
Image 50 of 76
50 of 76
Image 51 of 76
51 of 76
Image 52 of 76
52 of 76
Image 53 of 76
53 of 76
Image 54 of 76
54 of 76
Image 55 of 76
55 of 76
Image 56 of 76
56 of 76
Image 57 of 76
57 of 76
Image 58 of 76
58 of 76
Image 59 of 76
59 of 76
Image 60 of 76
60 of 76
Image 61 of 76
61 of 76
Image 62 of 76
62 of 76
Image 63 of 76
63 of 76
Image 64 of 76
64 of 76
Image 65 of 76
65 of 76
Image 66 of 76
66 of 76
Image 67 of 76
67 of 76
Image 68 of 76
68 of 76
Image 69 of 76
69 of 76
Image 70 of 76
70 of 76
Image 71 of 76
71 of 76
Image 72 of 76
72 of 76
Image 73 of 76
73 of 76
Image 74 of 76
74 of 76
Image 75 of 76
75 of 76
Image 76 of 76
76 of 76


Search Online Stores for MOTUC Castle Graysku

Found MOTUC Castle Graysku on Ebay
Search Ebay for MOTUC Castle Graysku Now


Advertise on
This site uses cookies for site configuration, advertising, and analysis. By using this site you accept our policies - Read Full Site Policy OK
Sign Up For The TNI Newsletter And Have The News Delivered To You!

Entertainment News International (ENI) is the #1 popular culture network for adult fans all around the world.
Get the scoop on all the popular comics, games, movies, toys, and more every day!

Contact and Support

Advertising | Submit News | Contact ENI | Privacy Policy

©Entertainment News International - All images, trademarks, logos, video, brands and images used on this website are registered trademarks of their respective companies and owners. All Rights Reserved. Data has been shared for news reporting purposes only. All content sourced by fans, online websites, and or other fan community sources. Entertainment News International is not responsible for reporting errors, inaccuracies, omissions, and or other liablities related to news shared here. We do our best to keep tabs on infringements. If some of your content was shared by accident. Contact us about any infringements right away - CLICK HERE